Projet de travail approuvé
ISO/AWI 15500-7
Véhicules routiers — Composants des systèmes de combustible gaz naturel comprimé (GNC) — Partie 7: Injecteur de gaz
Numéro de référence
ISO/AWI 15500-7
Edition 3
Projet de travail approuvé
ISO/AWI 15500-7
86554
Un groupe de travail a préparé un projet.
Remplacera ISO 15500-7:2015

Résumé

ISO 15500-7:2015 specifies tests and requirements for the gas injector and/or fuel rail, a compressed natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833.

ISO 15500-7:2015 is applicable to vehicles using natural gas in accordance with ISO 15403‑1 (mono-fuel, bi-fuel, or dual-fuel applications). It is not applicable to injectors intended for high-pressure injection to the combustion chamber, or to the following:

a) liquefied natural gas (LNG) fuel system components located upstream of, and including, the vaporizer;

b) fuel containers;

c) stationary gas engines;

d) container mounting hardware;

e) electronic fuel management;

f) refuelling receptacles.

NOTE 1 It is recognized that miscellaneous components not specifically covered herein can be examined to meet the criteria of this part of ISO 15500 and tested according to the appropriate functional tests.

NOTE 2 All references to pressure in this part of ISO 15500 are to be considered gauge pressures unless otherwise specified.

NOTE 3 This part of ISO 15500 is based upon a service pressure for natural gas as fuel of 20 MPa [200 bar[1]] settled at 15 °C. Other service pressures can be accommodated by adjusting the pressure by the appropriate factor (ratio). For example, a 25 MPa (250 bar) service pressure system will require pressures to be multiplied by 1,25.

[1] 1 bar = 0,1 MPa = 105 Pa 1 MPa = 1 N/mm2

Informations générales

  •  : Projet
    : Nouveau projet enregistré au programme de travail du TC/SC [20.00]
  •  : 3
  • ISO/TC 22/SC 41
  • RSS mises à jour

Vous avez une question?

Consulter notre Aide et assistance