International Standard
ISO 286-2:2010
Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
Reference number
ISO 286-2:2010
Edition 2
2010-06
© ISO 2024
International Standard
Read sample
Published (Edition 2, 2010)
This standard was last reviewed and confirmed in 2021. Therefore this version remains current.

ISO 286-2:2010

Format
Language
CHF 194
Convert Swiss francs (CHF) to your currency

Abstract

ISO 286-2:2010 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286‑1. ISO 286-2 covers values for the upper limit deviations eU, hole (for holes) and eU, shaft (for shafts) and the lower limit deviations eL, hole (for holes) and eL, shaft (for shafts).

The ISO system for tolerances on linear size provides a system of tolerances and deviations suitable for features of the following types:

  1. cylinders;
  2. two parallel opposite surfaces.

For simplicity, and also because of the importance of cylindrical workpieces of circular section, only these are referred to explicitly. It should be clearly understood, however, that the tolerances and deviations given in ISO 286-2 equally apply to workpieces of other than circular sections.

General information

  • Status
     : Published
    Publication date
     : 2010-06
    Stage
    : International Standard confirmed [90.93]
  • Edition
     : 2
    Number of pages
     : 52
  • Technical Committee :
    ISO/TC 213
    ICS :
    17.040.10 
  • RSS updates

Life cycle

Got a question?

Check out our FAQs

Customer care
+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)

  2. Store
  3. Standards catalogue
  4. ICS
  5. 17
  6. 17.040
  7. 17.040.10
  8. ISO 286-2:2010