Reference number
ISO 14530-3:1999
International Standard
ISO 14530-3:1999
Plastics — Unsaturated-polyester powder moulding compounds (UP-PMCs) — Part 3: Requirements for selected moulding compounds
Edition 1
1999-11
Preview
ISO 14530-3:1999
24623
недоступно на русском языке
Опубликовано (Версия 1, 1999)
Последний раз этот публикация был пересмотрен в  2020. Поэтому данная версия остается актуальной.

ISO 14530-3:1999

ISO 14530-3:1999
24623
Язык
Формат
CHF 42
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

This part of ISO 14530 specifies the requirements for the physical and chemical properties of unsaturated-polyester

powder moulding compounds (UP-PMCs) and compression- or injection-moulded test specimens produced from

them.

It is limited to those powder moulding compounds whose composition and properties are significantly different. It is

further limited to those moulding compounds which are of general technical and/or economic importance.

The properties which are used to characterize the moulding compounds, the test methods and the test conditions

are selected from those given in ISO 14530-2.

The moulding compounds are divided into types according to their composition and properties. The various types

are designated using the designation system defined in ISO 14530-1.

Общая информация

  •  : Опубликовано
     : 1999-11
    : Подтверждение действия международного стандарта [90.93]
  •  : 1
  • ISO/TC 61/SC 12
    83.080.10 
  • RSS обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ