Reference number
ISO 228-1:2000
International Standard
ISO 228-1:2000
Pipe threads where pressure-tight joints are not made on the threads — Part 1: Dimensions, tolerances and designation
Edition 4
2000-09
Preview
ISO 228-1:2000
33777
No disponible en español
Publicado (Edición 4, 2000)
Esta publicación se revisó y confirmó por última vez en 2022. Por lo tanto, esta versión es la actual.

ISO 228-1:2000

ISO 228-1:2000
33777
Idioma
Formato
CHF 63
Convertir Franco suizo (CHF) a tu moneda

Resumen

This part of ISO 228 specifies the requirements for thread form, dimensions, tolerances and designation for

fastening pipe threads, thread sizes 1/16 to 6 inclusive. Both internal and external threads are parallel threads,

intended for the mechanical assembly of the component parts of fittings, cocks and valves, accessories, etc.

These threads are not suitable as jointing threads where a pressure-tight joint is made on the thread. If assemblies

with such threads must be made pressure-tight, this should be effected by compressing two tightening surfaces

outside the threads, and by interposing an appropriate seal.

NOTE 1 For pipe threads where pressure-tight joints are made on the threads, see ISO 7-1.

NOTE 2 ISO 228-2 gives details of methods for verification of fastening thread dimensions and form, and recommended

gauging systems.

Informaciones generales

  •  : Publicado
     : 2000-09
    : Norma Internacional confirmada [90.93]
  •  : 4
     : 8
  • ISO/TC 5/SC 5
    21.040.30 
  • RSS actualizaciones

Ciclo de vida

¿Tiene alguna duda?

Consulte nuestras Ayuda y asistencia